Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 205)

Port Channel Commands
Page 204
Command Mode
Global Configuration mode
User Guidelines
Commands under the interface range context are executed independently on each interface in the range.
Example
The following example groups port-channels 1, 2 and 6 to receive the same command.
channel-group
The channel-group Interface Configuration (Ethernet) mode command associates a port with a port-channel. Use
the no form of this command to remove a port from a port-channel.
Syntax
channel-group port-channel-number
no channel-group
Parameters
•
port-channel-number — Specifies the number of the valid port-channel for the current port to join.
Default Configuration
The port is not assigned to a port-channel.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example forces port 1/e1 to join port-channel 1.
show interfaces port-channel
The show interfaces port-channel Privileged EXEC mode command displays port-channel information.
Syntax
show interfaces port-channel [port-channel-number]
console(config)# interface range port-channel 1-2,6
console(config)# interface ethernet 1/e1
console(config-if)# channel-group 1 mode on
01-Oct-2008 09:47:14 %LINK-W-Down: ch1
console(config-if)#