Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 79)

Clock Commands
Page 78
User Guidelines
The sntp client poll timer Global Configuration mode command determines polling time.
Use the sntp client enable (Interface) Interface Configuration mode command to enable the SNTP client on a
specific interface.
Example
The following example enables SNTP Anycast clients.
sntp client enable (Interface)
The sntp client enable Interface Configuration (Ethernet, port-channel, VLAN) mode command enables the
Simple Network Time Protocol (SNTP) client on an interface. This applies to both receive Broadcast and Anycast
updates. Use the no form of this command to disable the SNTP client.
Syntax
sntp client enable
no sntp client enable
Parameters
This command has no arguments or keywords.
Default Configuration
The SNTP client is disabled on an interface.
Command Mode
Interface configuration (Ethernet, port-channel, VLAN) mode
User Guidelines
Use the sntp broadcast client enable Global Configuration mode command to enable Broadcast clients globally.
Use the sntp anycast client enable Global Configuration mode command to enable Anycast clients globally.
Example
The following example enables the SNTP client on Ethernet port 1/e3.
sntp unicast client enable
The sntp unicast client enable Global Configuration mode command enables the device to use the Simple
Network Time Protocol (SNTP) to request and accept SNTP traffic from servers. Use the no form of this command
to disable requesting and accepting SNTP traffic from servers.
console(config)# sntp anycast client enable
Console(config)# interface ethernet 1/e3
Console(config-if)# sntp client enable