Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 217)

QoS Commands
Page 216
User Guidelines
There are no user guidelines for this command.
Example
The following example displays QoS attributes when QoS is disabled on the device.
priority-queue out num-of-queues
The priority-queue out num-of-queues Global Configuration mode command configures the number of expedite
queues. Use the no form of this command to return to the default configuration.
Syntax
priority-queue out num-of-queues number-of-queues
no priority-queue out num-of-queues
Parameters
•
number-of-queues — Specifies the number of expedite queues. The expedite queues are the queues with
higher indexes. (Available options: 0 and 4)
Default Configuration
All queues are expediting queues.
Command Mode
Global Configuration mode
User Guidelines
When the specified number of expedite queues is 0, all queues are assured forwarding (WRR).
When the specified number of expedite queues is 4, all queues are expedited.
Example
The following example configures the number of expedite queues as 0.
rate-limit
The rate-limit Interface Configuration mode command limits the rate of the incoming traffic. The no form of this
command is used to disable rate limiting.
Syntax
rate-limit rate
no rate-limit
console> show qos
Qos: disable
Trust: dscp
console(config)# priority-queue out num-of-queues 0