beautypg.com

Ip igmp snooping leave-time-out – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual

Page 132

background image

Page 131

Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide

no ip igmp snooping mrouter-time-out

Parameters

time-out — Multicast device timeout in seconds (Range: 1 - 2147483647)

Default Configuration

The default value is 300 seconds.

Command Mode

Interface Configuration (VLAN) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example configures the Multicast device timeout to 200 seconds.

ip igmp snooping leave-time-out

The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode command configures the leave-
time-out. If an IGMP report for a Multicast group was not received for a leave-time-out period after an IGMP Leave
was received from a specific port, this port is deleted from the member list of that Multicast group. Use the no form
of this command to return to the default configuration.

Syntax

ip igmp snooping leave-time-out {time-out | immediate-leave}

no ip igmp snooping leave-time-out

Parameters

time-out — Specifies the leave-time-out in seconds for IGMP queries. (Range: 0-2147483647)

immediate-leave — Indicates that the port should be immediately removed from the members list after

receiving IGMP Leave.

Default Configuration

The default leave-time-out configuration is 10 seconds.

Command Mode

Interface Configuration (VLAN) mode

User Guidelines

The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP
query.

console(config)# interface vlan 2

console(config-if)# ip igmp snooping mrouter-time-out 200