Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 213)

Power over Ethernet Commands
Page 212
The following table describes the significant fields shown in the example:
3/e1 Auto Low Off N/A
console# show power inline ethernet 4/e1
Port Powered
Device
State Status Priority Class
---- ------- ----------- ------------- ------------ --------
4/e1 Auto On low class1
Overload Counter: 0
Short Counter: 0
Denied Counter: 0
Absent Counter: 1
Invalid Signature Counter: 0
F i e l d D e s c r i p t i o n
Power The operational status of the inline power sourcing equipment.
Nominal Power The nominal power of the inline power sourcing equipment in Watts.
Consumed Power Measured usage power in Watts.
Usage Threshold The usage threshold expressed in percents for comparing the measured power
and initiating an alarm if threshold is exceeded.
Traps Indicates if inline power traps are enabled.
Port The Ethernet port number.
Powered Device Description of the powered device type.
State Indicates if the port is enabled to provide power. Can be: Auto or Never.
Priority The priority of the port from the point of view of inline power management. Can
be: Critical, High or Low.
Status Describes the inline power operational status of the port. Can be: On, Off, Test-
Fail, Testing, Searching or Fault.
Classification The power consumption range of the powered device. Can be: 0.44 – 12.95,
0.44 – 3.84, 3.84 – 6.49 or 6.49 – 12.95.
Overload Counter Counts the number of overload conditions that has been detected.
Short Counter Counts the number of short conditions that has been detected.
Denied Counter Counts the number of times power has been denied.
Absent Counter Counts the number of times power has been removed because powered device
dropout was detected.
Invalid Signature Counter Counts the number of times an invalid signature of a powered device was
detected.