Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 375)

802.1x Commands
Page 374
User Guidelines
It is recommended to disable spanning tree or to enable spanning-tree PortFast mode on 802.1x edge ports (ports
in auto state that are connected to end stations), in order to get immediately to the forwarding state after
successful authentication.
Example
The following example enables 802.1X authentication on Ethernet port 1/e16.
dot1x re-authentication
The dot1x re-authentication Interface Configuration mode command enables periodic re-authentication of the
client. Use the no form of this command to return to the default configuration.
Syntax
dot1x re-authentication
no dot1x re-authentication
Parameters
This command has no arguments or keywords.
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet)
User Guidelines
There are no user guidelines for this command.
Example
The following example enables periodic re-authentication of the client.
dot1x timeout re-authperiod
The dot1x timeout re-authperiod Interface Configuration mode command sets the number of seconds between
re-authentication attempts. Use the no form of this command to return to the default configuration.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
console(config)# interface ethernet 1/e16
console(config-if)# dot1x port-control auto
console(config)# interface ethernet 1/e16
console(config-if)# dot1x re-authentication