Show system – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 332

Page 331
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Example
The following example lists open Telnet sessions.
The following table describes significant fields shown above.
show system
The show system User EXEC mode command displays system information.
Syntax
show system [unit unit]
Parameters
•
unit— Specifies the number of the unit. (Range: 1-6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the system information
.
console> show sessions
Connection
Host
Address
Port
Byte
----------
-------------
----------
-----
----
1
Remote device
172.16.1.1
23
89
2
172.16.1.2
172.16.1.2
23
8
F i e l d
D e s c r i p t i o n
Connection
Connection number.
Host
Remote host to which the device is connected through a Telnet session.
Address
IP address of the remote host.
Port
Telnet TCP port number
Byte
Number of unread bytes for the user to see on the connection.
console# show system