Stack master – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 327

System Management Commands
Page 326
Example
The following example specifies the device host name.
stack master
The stack master Global Configuration mode command enables forcing the selection of a stack master. Use the
no form of this command to return to the default configuration.
Syntax
stack master unit unit
no stack master
Parameters
•
unit — Unit number of the new master (Range: 1-2)
Default Configuration
Disables forcing the selection of a stack master.
Command Mode
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The following algorithm is used to select a unit as the master:
•
If only one master-enabled unit is in the stack (1 or 2), it becomes the master.
•
If a unit configured as a forced master, it becomes the master.
If a forced master unit is removed from a stack and placed in a different stack with another forced master unit, both
are considered to be forced, and the election criteria continue as follows:
•
The unit with the longer up-time is elected master. Units are considered to have the same up-time if they were
powered up within ten minutes of each other.
•
If both forced master units have the same up-time, Unit 1 is elected.
Example
The following example selects Unit 2 as the stack master.
console(config)# hostname stack
stack(config)# no hostname
console(config)#
console(config)# stack master unit 2