Sntp server – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 81
Clock Commands
Page 80
Example
The following example enables polling for Simple Network Time Protocol (SNTP) predefined Unicast clients.
sntp server
The sntp server Global Configuration mode command configures the device to use the Simple Network Time
Protocol (SNTP) to request and accept SNTP traffic from a specified server. Use the no form of this command to
remove a server from the list of SNTP servers.
Syntax
sntp server {ipv4-address|ipv6-address|hostname} [poll] [key keyid]
no sntp server {ipv4-address|ipv6-address|hostname}
Parameters
•
ipv4-address — IPv4 address of the server. An out-of-band IP address can be specified as described in the
usage guidelines.
•
ipv6-address — IPv6 address of the server. An out-of-band IP address can be specified as described in the
usage guidelines. When the IPv6 address is a Link Local address (IPv6 address), the outgoing interface
name must be specified. Refer to the usage guidelines for the interface name syntax.
•
hostname — Hostname of the server. Only translation to IPv4 addresses is supported.
•
poll — Enable polling.
•
keyid — Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
•
Up to 8 SNTP servers can be defined.
•
To enable predefined Unicast clients globally use the sntp unicast client enable Global Configuration mode
command.
•
To enable global polling use the sntp unicast client poll Global Configuration mode command.
•
The sntp client poll timer Global Configuration mode command determines polling time.
•
The format of an IPv6 address is: <ipv6-link-local-address>%<interface-name>
interface-name = vlan<integer> | ch<integer> | isatap<integer> | <physical-port-name>
–
integer = <decimal-number> |
–
decimal-number = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
–
physical-port-name = Product specific.
Console(config)# sntp unicast client poll