Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 53)

Address Table Commands
Page 52
Chapter 4. Address Table Commands
bridge address
The bridge address Interface Configuration (VLAN) mode command adds a MAC-layer station source address to
the bridge table. Use the no form of this command to delete the MAC address.
Syntax
bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent permanent} |
delete-on-reset delete-on-reset} | delete-on-timeout delete-on-timeout} | secure secure]
no bridge address [mac-address]
Parameters
•
mac-address — A valid MAC address.
• interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
• permanent — The address can only be deleted by the no bridge address command.
• delete-on-reset — The address is deleted after reset.
• delete-on-timeout — The address is deleted after "age out" time has expired.
• secure — The address is deleted after the port changes mode to unlock learning (no port security
command). This parameter is only available when the port is in the learning locked mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Using the no form of the command without specifying a MAC address deletes all static MAC addresses belonging
to this VLAN).
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on port 1/e16
to the bridge table.
bridge multicast filtering
The bridge multicast filtering Global Configuration mode command enables filtering of Multicast addresses. Use
the no form of this command to disable filtering of Multicast addresses.
console(config)# interface vlan 2
console(config-if)# bridge address 3aa2.64b3.a245 ethernet 1/e16 permanent