Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 70)

Page 69
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays classes of entries in the port-lock status:
The following table describes the fields shown above.
show ports security addresses
The show ports security addresses Privileged EXEC mode command displays the current dynamic addresses
in locked ports.
Syntax
show ports security addresses [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
console# show ports security
Port Status Learning Action Maximum Trap Frequency
---- ------- -------- ------- ------- ------- ---------
1/e1 Locked Dynamic Discard 3 Enable 100
1/e2 Unlocked Dynamic - 28 - -
1/e3 Locked Disabled Discard,
Shutdown
8 Disable -
F i e l d D e s c r i p t i o n
Port Port number
Status Locked/Unlocked
Learning Learning mode
Action Action on violation
Maximum Maximum addresses that can be associated on this port in Static
Learning mode or in Dynamic Learning mode
Trap Indicates if traps are sent in case of a violation
Frequency Minimum time between consecutive traps