Snmp-server v3-host – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 253

SNMP Commands
Page 252
snmp-server v3-host
The snmp-server v3-host Global Configuration mode command specifies the recipient of Simple Network
Management Protocol Version 3 notifications. Use the no form of this command to remove the specified host.
Syntax
snmp-server v3-host {ipv4-address | ipv6-address | hostname} username [traps | informs] {noauth | auth |
priv} [udp-port port] [filter filtername] [timeout seconds] [retries retries]
no snmp-server host {ipv4-address | ipv6-address | hostname} username [traps | informs]
Parameters
•
ipv4-address — IPv4 address of the host (the targeted recipient). An out-of-band IP address can be specified
as described in the usage guidelines.
•
ipv6-address — IPv6 address of the host (the targeted recipient). When the IPv6 address is a Link Local
address (IPv6Z address), the outgoing interface name must be specified. Refer to the usage guidelines for
the interface name syntax.
•
hostname — Specifies the name of the host. (Range:1-158 characters)
•
username — Specifies the name of the user to use to generate the notification. (Range: 1-24)
•
traps — Indicates that SNMP traps are sent to this host.
•
informs — Indicates that SNMP informs are sent to this host.
•
noauth — Indicates no authentication of a packet.
•
auth — Indicates authentication of a packet without encrypting it.
•
priv — Indicates authentication of a packet with encryption.
•
port — Specifies the UDP port of the host to use. If unspecified, the default UDP port number is 162.
(Range: 1-65535)
•
filtername — Specifies a string that defines the filter for this host. If unspecified, nothing is filtered.
(Range: 1-30 characters)
•
seconds — Specifies the number of seconds to wait for an acknowledgment before resending informs. If
unspecified, the default timeout period is 15 seconds. (Range: 1-300)
•
retries — Specifies the maximum number of times to resend an inform request. If unspecified, the default
maximum number of retries is 3. (Range: 0-255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
•
A user and notification view are not automatically created. Use the snmp-server user, snmp-server group
and snmp-server view Global Configuration mode commands to generate a user, group and notify group,
respectively.
•
The format of an IPv6Z address is: <ipv6-link-local-address>%<interface-name>
interface-name = vlan<integer> | ch<integer> | isatap<integer> | <physical-port-name>
–
integer = <decimal-number> | nteger><decimal-number>
–
decimal-number = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9