beautypg.com

Show lldp med configuration – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual

Page 185

background image

LLDP Commands

Page 184

The following table describes the significant fields shown in the example:

show lldp med configuration

The show lldp med configuration Privileged EXEC mode command displays the LLDP MED configuration.

Syntax

show lldp med configuration [ethernet interface]

Parameters

interface — Ethernet interface.

Default Configuration

This command has no default configuration.

Command Mode

Privileged EXEC mode.

User Guidelines

There are no guidelines for this command.

F i e l d

D e s c r i p t i o n

Timer

Specifies how often the software sends LLDP updates.

Hold multiplier

Specifies the amount of time the receiving device should hold an LLDP packet
before discarding it.

Reinit timer

Specifies the minimum time an LLDP port waits before reinitializing LLDP
transmission.

Tx delay

Specifies the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB.

Port

The port number.

State

The port LLDP state.

Optional TLVs

Optional TLVs that are advertised. Possible values are:

PD – Port description

SN – System name

SD – System description

SC – System capabilities

Address

The management address that is advertised.