Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 150)

Page 149
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
– physical-port-name — Designated port number, for example e1.
• Configuring a new default gateway without deleting the previously configured information overwrites the
previous configuration.
• A configured default gateway has a higher precedence over one automatically advertised (via router
advertisement message).
Example
The following example defines an IPv6 default gateway.
show ipv6 interface
The show ipv6 interface Privileged EXEC mode command displays the usability status of configured IPv6
interfaces.
Syntax
show ipv6 interface [ethernet interface-number | vlan vlan-id | port-channel port-channel number ]
Parameters
•
ethernet interface-number — Valid Ethernet port.
• vlan vlan-id — Valid VLAN number.
• port-channel number — Valid Port-channel number.
Default Configuration
Displays all IPv6 interfaces.
Command Mode
Privileged EXEC mode.
User Guidelines
To display IPv6 neighbor discovery cache information, use the show ipv6 neighbors command in the Privileged
EXEC mode.
Examples
The following examples display the usability status of interfaces configured for IPv6.
console(config)# ipv6 default-gateway fe80::11
console# show ipv6 interface
Interface IP addresses Type
--------- ---------------------------- ----------
VLAN 1 FE80::9C0:876A:130B Dynamic
VLAN 17 FE80::9C0:876A:130D Dynamic
VLAN 17 2031:0:130F:0:0:9C0:876A:130D/64 Static