Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 178)

Page 177
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies the minimum time an LLDP port waits before reinitializing LLDP transmissions to
five seconds.
lldp tx-delay
The lldp tx-delay Global Configuration mode command specifies the delay between successive LLDP frame
transmissions initiated by value/status changes in the LLDP local systems MIB. Use the no form of this command
to revert to the default setting.
Syntax
lldp tx-delay seconds
no lldp tx-delay
Parameters
•
seconds — Specifies the delay, in seconds, between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB. (Range: 1 - 8192 seconds)
Default Configuration
The default value is 2 seconds.
Command Mode
Global Configuration mode.
User Guidelines
•
It is recommended that the TxDelay be less than 0.25 of the LLDP timer interval.
Example
The following example specifies the delay between successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB to 10 seconds.
lldp optional-tlv
The lldp optional-tlv Interface Configuration mode command specifies which optional TLVs from the basic set
should be transmitted. Use the no form of this command to revert to the default setting.
console(config) # lldp reinit-delay 5
console(config) # lldp tx-delay 10