Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 251)

SNMP Commands
Page 250
Syntax
snmp-server filter filter-name oid-tree {included | excluded}
no snmp-server filter filter-name [oid-tree]
Parameters
•
filter-name — Specifies the label for the filter record that is being updated or created. The name is used to
reference the record. (Range: 1-30 characters)
• oid-tree — Specifies the object identifier of the ASN.1 subtree to be included or excluded from the view. To
identify the subtree, specify a text string consisting of numbers, such as 1.3.6.2.4, or a word, such as system.
Replace a single subidentifier with the asterisk (*) wildcard to specify a subtree family; for example, 1.3.*.4.
• included — Indicates that the filter type is included.
• excluded — Indicates that the filter type is excluded.
Default Configuration
No filter entry exists.
Command Mode
Global Configuration mode
User Guidelines
This command can be entered multiple times for the same filter record. Later lines take precedence when an
object identifier is included in two or more lines.
Example
The following example creates a filter that includes all objects in the MIB-II system group except for sysServices
(System 7) and all objects for interface 1 in the MIB-II interfaces group.
snmp-server host
The snmp-server host Global Configuration mode command specifies the recipient of Simple Network
Management Protocol Version 1 or Version 2 notifications. Use the no form of this command to remove the
specified host.
Syntax
snmp-server host {ipv4-address | ipv6-address | hostname} community-string [traps | informs] [1 | 2] [udp-port
port] [filter filtername] [timeout seconds] [retries retries]
no snmp-server host {ipv4-address | ipv6-address | hostname} [traps | informs]
console(config)# snmp-server filter filter-name system included
console(config)# snmp-server filter filter-name system.7 excluded
console(config)# snmp-server filter filter-name ifEntry.*.1 included