Bridge multicast forbidden forward-all – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 57

Address Table Commands
Page 56
Syntax
bridge multicast forward-all {add | remove} {ethernet interface-list | port-channel port-channel-number-list}
no bridge multicast forward-all
Parameters
•
add — Force forwarding all Multicast packets.
•
remove — Do not force forwarding all Multicast packets.
•
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen is used to
designate a range of ports.
•
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no spaces; a hyphen
is used to designate a range of port-channels.
Default Configuration
This setting is disabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables all Multicast packets on port 1/e8 to be forwarded.
bridge multicast forbidden forward-all
The bridge multicast forbidden forward-all Interface Configuration mode command forbids a port to be a
Forward-all-Multicast port. Use the no form of this command to return to default.
Syntax
bridge multicast forbidden forward-all {add | remove} {ethernet interface-list | port-channel port-channel-
number-list}
no bridge multicast forbidden forward-all
Parameters
•
add — Forbid forwarding all Multicast packets.
•
remove — Do not forbid forwarding all Multicast packets.
•
interface-list — Separates nonconsecutive Ethernet ports with a comma and no spaces; use a hyphen to
designate a range of ports.
•
port-channel-number-list — Separates nonconsecutive port-channels with a comma and no spaces; use a
hyphen to designate a range of port-channels.
console(config)# interface vlan 2
console(config-if)# bridge multicast forward-all add
ethernet 1/e8