Chapter 32. tunnel commands, Interface tunnel, Tunnel mode ipv6ip – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 315: Chapter 32.tunnel commands, Interface tunnel tunnel mode ipv6ip, Chapter 32. "tunnel commands

Tunnel Commands
Page 314
Chapter 32.Tunnel Commands
interface tunnel
The interface tunnel Global Configuration mode command enters tunnel interface configuration mode.
Syntax
interface tunnel number
Parameters
•
number — Tunnel index.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enters tunnel interface configuration mode to configure tunnel 1.
tunnel mode ipv6ip
The tunnel mode ipv6ip Interface Tunnel Configuration mode command configures an IPv6 transition
mechanism global support mode. Use the no form of this command to remove the IPv6 transition mechanism.
Syntax
tunnel mode ipv6ip {isatap}
no tunnel mode ipv6ip
Parameters
•
isatap — Automatic IPv6 over IPv4 ISATAP tunnel is enabled.
Default Configuration
Disabled.
console(config)# interface tunnel 1
console(config-tunnel)#