Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 103)

Ethernet Configuration Commands
Page 102
description
The description Interface Configuration (Ethernet, port-channel) mode command adds a description to an
interface. Use the no form of this command to remove the description.
Syntax
description string
no description
Parameters
•
string — Comment or a description of the port to enable the user to remember what is attached to the port.
(Range: 1-64 characters)
Default Configuration
The interface does not have a description.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example adds a description to Ethernet port 1/e5.
speed
The speed Interface Configuration (Ethernet, port-channel) mode command configures the speed of a given
Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the default
configuration.
Syntax
speed {10 | 100 | 1000}
no speed
Parameters
•
10 — Forces 10 Mbps operation.
• 100 — Forces 100 Mbps operation.
• 1000 — Forces 1000 Mbps operation.
Default Configuration
Maximum port capability
console(config)# interface ethernet 1/e5
console(config-if)# description "RD SW#3"