Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 55)

Address Table Commands
Page 54
Command Mode
Interface configuration (VLAN) mode
User Guidelines
•
If the command is executed without add or remove, the command only registers the group in the bridge
database.
• Static Multicast addresses can only be defined on static VLANs.
Example
The following example registers the MAC address:
The following example registers the MAC address and adds ports statically.
bridge multicast forbidden address
The bridge multicast forbidden address Interface Configuration mode command forbids adding specific
Multicast addresses to specific ports. Use the no form of this command to return to default.
Syntax
bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add | remove} {ethernet
interface-list | port-channel port-channel-number-list}
no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address}
Parameters
•
add — Adds ports to the group.
• remove — Removes ports from the group.
• mac-multicast-address — A valid MAC Multicast address.
• interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; hyphen is used to
designate a range of ports.
• port-channel-number-list — Separate nonconsecutive valid port-channels with a comma and no spaces; a
hyphen is used to designate a range of port-channels.
Default Configuration
No forbidden addresses are defined.
Command Modes
Interface Configuration (VLAN) mode
console(config)# interface vlan 8
console(config-if)# bridge multicast address 01:00:5e:02:02:03
console(config)# interface vlan 8
console(config-if)# bridge multicast address 01:00:5e:02:02:03 add ethernet 1/e1-9, 2/
e2