Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 16)

Page 15
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
• Chapter 25. "Radius Commands" — Specify the source IP address used for communication with Remote
Authentication Dial-in User Service (RADIUS) servers, and display the RADIUS server settings.
• Chapter 26. "RMON Commands" — Display the Remote Network Monitoring (RMON) Ethernet history
statistics, alarms table and configuration.
• Chapter 27. "SNMP Commands" — Configure the community access string to permit access to the Simple
Network Management Protocol (SNMP) server, create or update SNMP server entries, and specify SNMP
engineID.
• Chapter 28. "Spanning-Tree Commands" — Configure the spanning-tree functionality.
• Chapter 29. "SSH Commands" — Display the Secure Socket Shell (SSH) public keys on the device, SSH
server configuration, or which SSH public key is manually configured.
• Chapter 30. "Syslog Commands" — Log messages to a syslog server, or limit log messages to a syslog
server.
• Chapter 31. "TACACS+ Commands" — Display configuration and statistical information about a Terminal
Access Controller Access Control System (TACACS+) server, or specify a TACACS+ host.
• Chapter 32. "Tunnel Commands" — Configure interface tunnel commands.
• Chapter 33. "System Management Commands" — Display and list system, version or Telnet session
information.
• Chapter 34. "User Interface Commands" — Display and list system, version or Telnet session information.
• Chapter 35. "VLAN Commands" — Enter the (Virtual Local Area Network) VLAN Configuration mode,
enable simultaneously configuring multiple VLANs, or adds or remove VLANs.
• Chapter 36. "Web Server Commands" — Enable configuring the device from a browser, or display the
HTTP server configuration.
• Chapter 37. "802.1x Commands" — Specify authentication, authorization and accounting (AAA) methods
for use on interfaces running IEEE 802.1x, and enable 802.1x globally.
Intended Audience
This guide is intended for network administrators familiar with IT concepts and terminology.
Document Conventions
This document uses the following conventions:
Note
Provides related information or information of special importance.
Caution
Indicates potential damage to hardware or software, or loss of data.
Warning
Indicates a risk of personal injury.