Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 391)

802.1x Commands
Page 390
Parameters
•
sec — Specify the timeout in seconds. (Range: 30 – 180)
Default Configuration
The guest VLAN is applied immediately.
Command Mode
Global Configuration mode.
User Guidelines
This command is relevant if the guest VLAN is enabled on the port. Configuring the timeout adds delay from
enabling 802.1X (or port up) to the time the switch puts the port in the guest VLAN
Example
The following example configures the delay from enabling 802.1X (or port up) to adding the port to the guest VLAN
to 50 seconds.
dot1x radius-attributes vlan
Use The dot1x radius-attributes vlan Interface Configuration command enables user-based VLAN assignment.
Use the no form of this command to disable user-based VLAN assignment..
Syntax
dot1x radius-attributes vlan
no dot1x radius-attributes vlan
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command configurations allowed only when the port is Forced Authorized.
Radius attributes are supported only in the multiple sessions mode (multiple hosts with authentication).
When Radius attributes are enabled and the Radius Accept message does not contain as an attribute the
supplicant’s VLAN then the supplicant is rejected.
Packets to the supplicant are sent untagged.
console# configure
console(config)# dot1x guest-vlan timeout 50