Allied Telesis AT-S94 CLI (AT-8000S Series) - Manual (Page 101)

Ethernet Configuration Commands
Page 100
Chapter 8. Ethernet Configuration Commands
interface ethernet
The interface ethernet Global Configuration mode command enters the interface configuration mode to configure
an Ethernet type interface.
Syntax
interface ethernet interface
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables configuring Ethernet port 5/e18.
interface range ethernet
The interface range ethernet Global Configuration mode command configures multiple Ethernet type interfaces
at the same time.
Syntax
interface range ethernet {port-list | all}
Parameters
•
port-list — List of valid ports. Where more than one port is listed, separate nonconsecutive ports with a
comma and no spaces, use a hyphen to designate a range of ports and group a list separated by commas in
brackets.
• all — All Ethernet ports.
Default Configuration
This command has no default configuration.
console(config)# interface ethernet 5/e18