beautypg.com

Dot1x max-req – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual

Page 378

background image

Page 377

Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide

Default Configuration

Timeout period is 30 seconds.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients. and authentication servers

Example

The following command sets the number of seconds that the device waits for a response to an EAP-request/
identity frame, to 3600 seconds.

dot1x max-req

The dot1x max-req Interface Configuration mode command sets the maximum number of times that the device
sends an Extensible Authentication Protocol (EAP)-request/identity frame (assuming that no response is
received) to the client, before restarting the authentication process. Use the no form of this command to return to
the default configuration.

Syntax

dot1x max-req count

no dot1x max-req

Parameters

count — Number of times that the device sends an EAP-request/identity frame before restarting the

authentication process. (Range: 1-10)

Default Configuration

The default number of times is 2.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients. and authentication servers

console(config)# interface ethernet 1/e16

console(config-if)# dot1x timeout tx-period 3600