Allied Telesis AT-FS970M Series - Manual (Page 328)

Chapter 26: sFlow
328
The sFlow Port Modify page is displayed. See Figure 147.
Figure 147. sFlow Port Modify Page
4. Change the following fields as needed:
 Interface— Indicates the port ID. You cannot change this
parameter on this page.
 Polling Interval— Enter the polling interval for the port. This
controls the maximum amount of time permitted between
successive pollings of the packet counter on the port by the sFlow
agent.
 Sample Rate— Enter the packet sampling rate on the port. The
sampling rate dictates the number of ingress packets from which
one sample is taken on a port and sent by the agent to the sFlow
collector. For example, a sample rate of 700 on a port means that
one sample packet is taken for every 700 ingress packets. The
possible values are 0 and 256 to 16,441,700 packets. Entering the
value 0 disables packet sampling.
5. Click Apply.
6. Click SAVE to save your changes to the startup configuration file.