Allied Telesis AT-FS970M Series - Manual (Page 278)

Chapter 24: Managing the ARP Table
278
Adding a Static ARP Entry
To add a static ARP entry, do the following:
1. Hover the cursor over the Layer 3 tab.
The Layer 3 tab is displayed. See Figure 119 on page 277.
2. From the Layer 3 tab drop-down menu, select ARP Table.
The ARP table is displayed. See Figure 120 on page 277.
3. Click Add.
The Add Static ARP Page is displayed. See Figure 121.
Figure 121. Add Static ARP Page
4. Enter the following settings:
 IP Address— Enter the IPv4 address of the host to create an ARP
entry.
 MAC Address— Enter the MAC address that is associated to the
IP address.
 VLAN— Select a VLAN from the drop-down menu. The port is
where the host is connected.
 Interface— Select a port ID to where the host is connected from
the drop-down menu, for example, 1.0.1.
5. Click Add.