Allied Telesis AT-FS970M Series - Manual (Page 314)

Chapter 25: LLDP and LLDP-MED
314
Displaying LLDP and LLDP-MED Settings
To display the LLDP and LLDP-MED settings, use the following
procedures:
 “Displaying the Basic LLDP Configuration” on page 314
 “Displaying LLDP Port Assignments” on page 315
 “Displaying Port Locations” on page 316
 “Displaying LLDP TLV” on page 316
 “Displaying LLDP-MED TLV” on page 318
For information about configuring LLDP and LLDP-MED, see “Assigning
LLDP Locations to a Port” on page 302.
Displaying the
Basic LLDP
Configuration
To display the basic LLDP configuration, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122 on
page 284.
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears to the right.
3. From the LLDP tab, select Basic Configuration.
The LLDP Configuration page is displayed. See Figure 123 on page
285.
The following fields are displayed:
 Status— Indicates whether LLDP is enabled or disabled on the
switch.
 Timer— Transmit interval.
 Fast Start Count— Fast start count for LLDP-MED. The fast start
count determines how many fast start advertisements LLDP sends
from a port when it begins sending LLDP-MED advertisements
from a port, for instance, when it detects a new LLDP-MED
capable device.
 Holdtime Multiplier— Holdtime multiplier value. The transmit
interval is multiplied by the holdtime multiplier to give the Time To
Live (TTL) the switch advertises to the neighbors.
 Non Strict Med TLV Order Check— Indicates whether the switch
accepts LLDP-MED advertisements when the TLVs are not in the
standard order, as specified in ANSI/TIA-1057.