Allied Telesis AT-FS970M Series - Manual (Page 116)

Chapter 9: Link Aggregation Control Protocol (LACP)
116
5. Enter an aggregator ID number in the Aggregator ID field. The
number can be from 1-32.
6. Select the Load Balance Method. Choose from the following:
 Src MAC— Source MAC address as the load distribution method.
 Dst MAC— Destination MAC address as the load distribution
method.
 Src-Dst MAC— Source address and destination MAC address as
the load distribution method.
 Src IP— Source IP address as the load distribution method.
 Dst IP— Destination IP address as the load distribution method.
 Src-Dst IP— Source IP address and destination IP address as the
load distribution method.
7. Click a port number to add to the aggregator. A green check mark
indicates a port has been selected. You can select multiple ports.
To deselect a port, click the box that indicates the port number.
8. Click Add.
A confirmation message is displayed.
9. Click SAVE to save your changes to the startup configuration file.