Allied Telesis AT-FS970M Series - Manual (Page 243)

243
Chapter 21
Setting Static Routes
To make remote networks communicate, you must add static routes or
dynamic routes, or both, to the routing table. Static routes are configured
manually to add routing information to the routing table. This chapter
provides information about static routes.
The procedures in this chapter describe how to display a list of static
routes on the switch, and how to add and delete a static route. See the
following sections:
 “Displaying Static Routes” on page 244
 “Adding a Static Route” on page 245
 “Deleting a Static Route” on page 247
 “Displaying the Routing Table” on page 248
For more information about static routes, see the following chapters in the
AT-FS970M Series Version 2.3.1.0 Management Software Command Line
Interface User’s Guide:
 Internet Protocol Version 4 Packet Routing
 IPv4 Routing Commands