Allied Telesis AT-FS970M Series - Manual (Page 315)

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
315
 Notification Interval— Notification interval. This is the minimum
interval between LLDP SNMP notifications (traps).
 Reinit— Reinitialization delay. This is the number of seconds that
must elapse after LLDP is disabled on a port before it can be
reinitialized.
 Tx Delay— Transmission delay. This is the minimum time interval
between transmissions of advertisements due to changes in LLDP
local information.
 Total Neighbors— Number of LLDP neighbors the switch has
discovered on all its ports.
 Neighbors Last Update— Time since the LLDP neighbor table
was last updated.
Displaying LLDP
Port Assignments
To display LLDP port assignments, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122 on
page 284.
2. From the Discovery & Monitoring tab, hover over LLDP, move the
cursor to the right and then select Port Configurations.
The LLDP Port Config page is displayed. See Figure 124 on page 288.
The following fields are displayed:
 Interface— Port ID.
 Notification— Indicates whether the switch sends LLDP-MED
topology change notifications when devices are connected to, or
disconnected from, the specified ports.
 Adv. Transmit— Indicates whether the port sends LLDP
advertisements. Ports configured to transmit LLDP advertisements
send the mandatory TLVs and any optional LLDP TLVs they have
been specified to send.
 Adv. Receive— Indicates whether the port accepts LLDP
advertisements. Ports configured to receive LLDP advertisements
accept all advertisements from their neighbors.
 MED Notifications— Indicates whether the switch sends LLDP-
MED topology change notifications when devices are connected
to, or disconnected from, the specified ports.