Allied Telesis AT-FS970M Series - Manual (Page 318)

Chapter 25: LLDP and LLDP-MED
318
Displaying
LLDP-MED TLV
To display LLDP-MED TLV settings, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122 on
page 284.
2. From the Discovery & Monitoring tab, hover over LLDP and then
hover over TLV.
The LLDP TLV tab is displayed. See Figure 126 on page 290.
3. From the LLDP TLV tab, move the cursor to the right and select TLV-
MED.
The LLDP-Med TLV page is displayed. See Figure 138 on page 304.
The following fields are displayed:
 Interface— Port ID.
 Capabilities— Device’s router and bridge functions, and whether
or not these functions are currently enabled.
 Network-policy— Network policy information specified on the port
for connected media endpoint devices. The switch supports
Application Type 1: Voice, including the following network policy
for connected voice devices to use for voice data:
- Voice VLAN ID
- Voice VLAN Class of Service (CoS) priority
- Voice VLAN Diffserv Code Point (DSCP)
 Location— Location information specified for the port, in one or
more of the following formats:
- Civic location
- Coordinate location
- Emergency Location Identification Number (ELIN)
 Inventory-management— Current hardware platform and the
software version, identical on every port on the switch:
- Hardware Revision
- Firmware Revision
- Software Revision
- Serial Number
- Manufacturer Name