Adding a radius server – Allied Telesis AT-FS970M Series User Manual
Page 193

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
193
AAA Accounting— Select a RADIUS accounting setting. Choose
from the following:
Start-Stop: Indicates that a start accounting message is sent at
the beginning of a session, and a stop accounting message is
sent at the end of the session.
Stop-Only: Indicates a stop accounting message is sent at the
end of the session.
None: Indicates that sending accounting messages is disabled.
4. Click Apply.
The Active Authentication Server field shown on the upper middle of
the page indicates “RADIUS.”
5. Click SAVE to save your changes to the startup configuration file.
Adding a
RADIUS Server
To add a RADIUS server, do the following:
1. Click Add near the RADIUS server list.
The RADIUS Server Add page is displayed. See Figure 72.
Figure 72. RADIUS Server Add Page
2. Configure the following as needed:
IP Address— Enter the IP address of a RADIUS server on the
network. The IP address must be in the following IPv4 format:
xxx.xxx.xxx.xxx.