Allied Telesis AT-FS970M Series - Manual (Page 293)

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
293
 Management Address— Check the checkbox to select the IP
address of the local LLDP agent to be included in LLDPDUs.
 Port VLAN— Check the checkbox to select the VID of the
untagged VLAN in which the transmitting port is a member to be
included in LLDPDUs.
 Port and Protocol VLANs— Check the checkbox to select
whether the device supports protocol VLANs and, if it does, the
protocol VLAN identifiers to be included in LLDPDUs.
 VLAN Names— Check the checkbox to select a list of the names
of the VLANs in which the transmitting port is either an untagged or
tagged member to be included in LLDPDUs.
 Protocol IDs— Check the checkbox to select a list of protocol IDs
that are accessible through the port to be included in LLDPDUs.
For instance:
- 9000 (Loopback)
- 0026424203000000 (STP, RSTP, or MSTP)
- 888e01 (802.1x)
- AAAA03 (EPSR)
- 88090101 (LACP)
- 00540000e302 (Loop protection)
- 0800 (IPv4)
- 0806 (ARP)
- 86dd (IPv6)
 MAC Phy Config— Check the checkbox to select the physical
layer information, including the link speed, duplex mode, and Auto
-Negotiation setting to be included in LLDPDUs.
 Power Management— Check the checkbox to select the power
via MDI capabilities of the port to be included in LLDPDUs.
 Link Aggregation— Check the checkbox to include whether the
port is capable of link aggregation and, if so, whether it is currently
a member of an aggregator in LLDPDUs.
 Max Frame Size— Check the checkbox to include the maximum
supported frame size of the port in LLDPDUs. This field is not
adjustable on the switch.
7. Click Apply.
8. Click SAVE to save your changes to the startup configuration file.