Videotec MAXIMUS MPXT - Manual (Page 62)

EN - English - I
nstruc
tions manual
60
Plug the cable (01), situated in the junction box, in
the reset switch board. Keep pressed the reset button
while reconnecting the power supply.
FUSE
FUSE
100nMBW3
L
N
VAR3
VAR1 AC
AL1
AL2
AL3
AL4
AL5
COM
RL1
RL1
RL2
RL2
GND
W
GND
B
A
B
A
IN J1
J6
J2
J3 J8
J7
FUS1
VAR2
VIDEO - 1
VIDEO - 2
RS485
FUS2
J9
01
02
Fig. 120
Keep the button pressed for 5 seconds and then
release it. The factory default values of the unit are
restored.
Repeat the procedure with the cable of the thermal
camera(02), if present.
When finished change the O-ring gasket (new O-ring
is in the package), lubricate it and the threads with
technical vaseline oil.
Screw the threaded cover of the junction box and
fix the hexagon set screw proceeding in the reverse
order as shown in Fig. 119, page 59.
9.7.3 Installing the NVR software
A CD-ROM containing display and control software is
supplied for controlling the various units. Follow the
instructions below to install the software correctly.
Insert the CD-ROM in the player, and after a few
seconds the following introductory display will
appear.
Fig. 121
Select Videotec NVR Professional and follow the
instructions that appear on the screen.
When you have completed installation, and the pan
& tilts have been configured as appropriate (see
previous section), you can run the NVR software to
make the initial settings for the system.
Start the Activemonitor software.
You will have to insert the usual User Name (default:
Admin) and Password (default: 123456)