Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 97)

PF3000 Flexicoil Flexcontrol
Ag Leader Technology Application Rate Mode
April 2002 2-81
Ground Speed Sensor: Set primary speed sensor to SERIAL. The
monitor will get ground speed from the serial cable connection to
the Flexcontrol. Leave the secondary speed sensor set to WHEEL
and do not change the Speed Sensor Pulses/100 ft. Also do not
perform a distance calibration using wheel selection. No
calibration is needed when primary speed is set to SERIAL.
Note: This setting affects all configurations.
App Distance From GPS: Set to distance between where product
exits applicator and position of GPS antenna on vehicle. Example:
If the boom is 20 feet behid GPS antenna set to 20 feet back. Press
DOWN ARROW key to set feet back, UP ARROW key to set feet
forward.
Full Swath: Ignore setting. Swath automatically comes from
serial port of Flexcontrol. The swath on the PF automatically
changes as boom sections are turned ON or OFF.
Tgt Units: Contrler Units: Normally set to 1:1.0000. This ratio
is used to convert the units in a .tgt prescription file to the units of
application.
Example: Tgt file in pints/ac of Treflan, Flexcontrol
applies based on gallons/ac. If tank mix is 1 pint of Treflan
/ 10 gallon water, then set to 1:10.0000. The PF will read
the pints/acre rate out of the .tgt file, multiply it by ten to
convert it to gallons/ac and send that rate to the
Flexcontrol console as the rate to be applied.
Target Rate Increment: Determines increment value by which
you can change the manual target rate with each press of Up or
Down arrow keys. Choices are 0.1, 1.0, 10.0, 100.0, 500.0, 1000.0,
5000.0 or 10000.0. For applying fertilizer or liquid use 1.0 or 10.0.