Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 135)

PF3000 Calibrating Stop Height
Ag Leader Technology (Harvest Mode)
April 2002 3-19
Introduction The stop height is the height at which the head must be raised at the end of a
pass to shut off area counting. The stop height number is a reference
number for the monitor to determine the height of the head. It does not
pertain to feet or inches of height.
The stop height number must be set for each grain type.
You must have the monitor installed in the combine to set the stop height.
Stop Height
To view the stop height calibration screen press the:
Calibration
Screen
MENU key
CAL key
bottom RIGHT ARROW key
STOP HGT key
Calibration STOP HEIGHT CALIBRATION:
Procedure
SELECT GRAIN:
SOYBEANS
ENTER
HEIGHT
CAL
C1
CAL
DISTANCE
EXIT