Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 224)

Troubleshooting PF3000
Harvest Mode Ag Leader Technology
April 2002 6-2
Problem Cause Solution
Bu/Ac or lbs/Ac Yield
too high or low. Average and
instantaneous yields
do not agree. See “Average and Instantaneous Yield Do Not
Agree” in this section..
You are not counting
the correct amount of
acres. Display AREA on the screen of the PF3000 to
show the total acres. If they are incorrect for the
field of load, see “Incorrect Acre Counting” in this
section.
Weight in pound is
inaccurate. See Incorrect Grain Weight (lbs) in this section.
Moisture is
inaccurate.
Dry moisture is set
incorrectly. Display INST MOIST on the screen of the PF3000
to show the moisture. If it is incorrect, see
“Incorrect Moisture” in this section.
Press MENU, SETUP, and GRAIN. Select the
grain type being harvested by using the up/down
arrow keys. Press EDIT SETTINGS. Check the
dry moisture value (percent moisture that dry
bushels are reduced to. e.g. 13% for soybeans,
15.5% for corn). Use the up/down arrow keys to
select the DRY MOISTURE line, then press EDIT.
Use the up/down arrow keys to set the dry
moisture to the correct value for the grain type
being harvested. The monitor corrects the yields
of previous loads harvested of that grain type.
The load you are
harvesting is set on
the wrong grain type. It is not possible to change grain type on an
existing load. If an incorrect grain type has been
selected, the entire field will need to be changed to
the correct grain type. The load with the wrong
grain type will remain in memory. There can be
more than one-grain type for each field.