Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 16)

Setup Overview PF3000
Ag Leader Technology
April 2002 2-2
Important Notices The PF3000 must be set up before field operation, but before you begin the
setup procedures, read the following notices:
•
The PF3000 is a software upgradeable monitor. Ag Leader Technology
will periodically offer free operating program upgrades to increase the
capabilities of the PF3000. To receive the program upgrade, you
must send in the registration form found at the beginning of the
operator’s manual.
•
If you plan to make yield maps on your own computer, you will need to
use a mapping program that can process files created by the PF3000.
Section Contents This setup section contains instructions for the following items. The
operating modes that the instructions pertain to are also listed.
Item Operating Mode Page
Console Setup All 2-6
Card Setup All 2-8
Creating, Naming Fields and Loads All 2-12
Marker Setup All 2-17
GPS Setup All 2-19
Vehicle Setup Harvest 2-30
Grain Setup Harvest 2-34
Swath Setup Harvest 2-39
Swath Setup Site Verification 2-41
Vehicle Site Verification 2-42
Controller Setup Application Rate 2-44
Raven Controller ( with Serial Ports) Application Rate 2-44
Mid-Tech Controller Application Rate 2-49
DICKEY-john Land Manager Application Rate 2-55
DICKEY-john Seed Manager Application Rate 2-61
Rawson Accu-Rate/Accu-Plant Application Rate 2-65
New Leader Mark III/Mark IV Application Rate 2-73
Flexicoil Flexcontrol Application Rate 2-79
Hiniker 8605 Application Rate 2-85
Teejet 844 Application Rate 2-90
Flowmeter Controller Application Rate 2-95
Using Power
Supply The PF3000 console does not need to be in the vehicle to set it up. You can
use the provided power supply (plugs into 120v outlet) to power up the