Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 87)

PF3000 Rawson Accu-Rate/Accu-Plant
Ag Leader Technology Application Rate Mode
April 2002 2-71
Dry fertilizer mode - Press MODE key on processor to view
“Del. Rate=xxx.xx”, “Mat’l=xxx.x Lb”, “Rate Setting xx.xx”
and “Ratio=xx.xx:1” setting.
Del. Rate x Mat'l x Rate Setting x .5787
Ratio
= cal. number
NOTE: Actual rate will be 1/10
th
of real actual rate
(except for lime). If cal. number is over 6400, divide cal.
number by 10. Ex. 7000/10=700 (act. rate will be 1/100
th
of real actual rate). If gate setting changes, switch
configurations and enter new cal. number.
Actual Rate Source: Set to DRIVE RPM. Actual Rate will be
determined based on rpm of hydraulic drive. If you are planting
and have a Dickey-john Seed Manager monitor and you want to
get the actual rate from it, set this to SEED MANGR.
2. Press EXIT key to return to screen with ADVANCED SETTINGS
key on bottom. Press the ADVANCED SETTINGS key.
Target Rate Outside Field: This only pertains to using a target
file.
Set to ZERO if want rate outside field to be zero.
Set to USE LAST if want rate to be the last rate used at the time
the vehicle is detected outside the field. This is useful when
experiencing problems with the vehicle being falsely detected
outside of the field during the outside pass.
Set to TGT DEFAULT if want rate outside field to be the default
rate stored in the target rate file.
Controller Time Delay: Set to 2 seconds. This is delay of
controller to change application equipment to new rate + 2
seconds.
Actual Rate Units: Ignore this setting.
Log Actual Rate: Set to YES to log actual rate to card. Set to
NO, otherwise.