Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 28)

Creating, Naming Fields, Loads PF3000
All Modes except App Rate Ag Leader Technology
April 2002 2-12
Recommendations NOTE: If using Application Rate Mode, refer to the Controller
Setup instructions on how to create and change fields. Refer to this
section for how to name fields and loads.
All the information recorded by the PF3000 must be recorded in a field and
load. The field and load that the monitor is set on is located on the top line
of the display on the main operating screen.
Fields
You should at least create all the fields and name them before you begin to
use the PF3000. The monitor will use the same set of fields you create for
each operating mode (harvest mode, application rate mode, site verification)
of the monitor. You can create and name your fields using any operating
mode. You should choose field names that you can use year after year.
Loads
It also recommended to create and name loads within fields before you use
the PF3000. Each operating mode of the PF3000 will have its own set of
loads for each field.
Definition:
Load: A load is used to subdivide a field into smaller sections. The
monitor load is not associated with the combine tank, wagon, or
truck load.
Field
Load