Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 223)

PF3000 Troubleshooting
Ag Leader Technology Harvest Mode
April 2002 6-1
Introduction Use the procedures on the following pages to troubleshoot, calibration,
operation, and installation problems. If you cannot pinpoint the problem,
call Ag Leader Technology at 515-232-5363 (fax: 515-232-3595).
If you think you have a hardware failure, call Ag Leader Technology and a
service unit or replacement hardware will be shipped to you immediately.
Subject Mode Page
Bu/Ac Yield Too High or Low Harvest 6-2
Yield in Bu/Ac Always Zero Harvest 6-6
Zero Flow in Bu/Hr Harvest 6-6
Incorrect Acre Counting Harvest 6-8
Incorrect Moisture Harvest 6-9
Moisture Readings of 5% or Erratic Harvest 6-9
Moisture is too high or too low Harvest 6-9
Moisture readings are high Harvest 6-9
Moisture reading goes to 5% Harvest 6-10
Moisture reading decreases drastically/suddenly Harvest 6-10
Erratic moisture sensor signal with moisture
sensor installed in auger tube Harvest 6-10
Moisture continually reads 5% with elevator
mount Harvest 6-10
Auger doesn’t come on moisture remains constant Harvest 6-11
Average and Instantaneous Yield Do Not Agree Harvest 6-11
Incorrect Grain Weight (lbs) Harvest 6-11
Elevator Speed is Zero or Erratic Harvest 6-12
Incorrect Temperature Reading Harvest 6-13
AREA OFF Always Displayed Harvest 6-13
Monitor Chirps While Harvesting Harvest 6-14
High Yield Reading After Stopping Harvest 6-14
Incorrect Distance and MPH Harvest 6-14
Monitor Has No Display All 6-16
No GPS Signal All 6-16
No Marks on Map using External Field Marker All 6-17
On Screen Map Does Not Appear All 6-17