Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 196)

Printing Field/Load Summary PF3000
Harvest Mode Ag Leader Technology
April 2002 4-56
Step Action
8 Make the following settings in the “Comx Properties” popup, then
click on OK when you are done.
•
Bits per second = 9600
•
Stop bits = 1
•
Data bits = 8
•
Flow control = None
•
Parity = None
9 Follow these steps to set file properties:
Step Action
1 Click on File on the menu bar.
2 Click on Properties. A popup labeled “(name you entered)
Properties” appears.
3 Click on Settings to the right of the phone number tab.
4 Click on ASCII Setup.
5 Click on the check mark next the last setting, wrap lines
that exceed terminal width to make the mark disappear.
6 Click on OK twice to return to the main HyperTerminal
screen.
Follow these steps to set the monitor to communicate with your computer:
Step Action
1 Turn on the PF3000.
2 After the monitor displays the currently selected field (it does not
make any difference which field the monitor is set on), press the
Menu Key, SETUP, MEMORY, PRINT SUMMARY “Print Field
Summary” will appear on the display.
3 Press Enter (or Return) on the PC keyboard. If “Type PRINT,
NAME or START & press Enter” appears on the PC display every
time you press Enter, you have established proper communications.
If “Type PRINT, NAME or START & press Enter” does not appear on the
PC display, perform the following procedures:
•
Follow these steps to recheck the parameters you set: in the Properties
window under the File menu by clicking on the Configure button.