Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 85)

PF3000 Rawson Accu-Rate/Accu-Plant
Ag Leader Technology Application Rate Mode
April 2002 2-69
Units: Set to Units/Acre of application. Set to SEEDS if planting.
Set to TONS if applying lime. Set to POUNDS if applying
fertilizer. Set to GALLONS if applying liquid.
Ground Speed Sensor: Set to RADAR or GPS. All Ag Leader
GPS except GPS 1000 will work for ground speed. If getting actual
rate from Seed Manger Planter monitor set to SERIAL.
Note: This setting affects all configurations
App Distance From GPS: Set to distance between where product
exits applicator and position of GPS antenna on vehicle. Example:
If the planter is 20 feet behid GPS antenna set to 20 feet back.
Press DOWN ARROW key to set feet back, UP ARROW key to set
feet forward.
Full Swath: Set to full swath of applicator.
Tgt Units: Contrler Units: Normally set to 1:1.0000. This ratio is
used to convert the units in a target file (.tgt) to the units of
application. Example: Tgt file in pounds/ac of lime, Rawson
applies lime in tons/ac. Set to 1:0.0005 to convert pounds/acre to
tons/ac. The PF will read the rate from the .tgt prescription file and
multiply it by 0.0005 and send that rate to the Rawson processor.
Target Rate Increment: Determines increment value by which you
can change the manual target rate with each press of Up or Down
arrow keys. Choices are 0.1, 1.0, 10.0, 100.0, 500.0, 1000.0,
5000.0 or 10000.0. Suggested setting when planting corn is 500.0
or 1000.0. For planting beans use 1000.0 or 5000.0 or 10000.0.
For applying lime use 0.1. For applying fertilizer or liquid use 1.0
or 10.0.
Actual Rate Scale Factor: Set to 1.000.
Press CONTRLER SETTINGS key. Set the following: