Ag Leader PF3000 Harvest & Application Operators Manual - Manual (Page 93)

PF3000 New Leader Controller
Ag Leader Technology Application Rate Mode
April 2002 2-77
Target Rate Outside Field: This only pertains to using a target
file.
Set to ZERO if want rate outside field to be zero.
Set to USE LAST if want rate to be the last rate used at the time
the vehicle is detected outside the field. This is useful when
experiencing problems with the vehicle being falsely detected
outside of the field during the outside pass.
Set to TGT DEFAULT if want rate outside field to be the default
rate stored in the target rate file.
Controller Time Delay: Set to 2 seconds. This is delay of
controller to change application equipment to new rate + 2
seconds.
Actual Rate Units: Ignore this setting.
Log Actual Rate: Set to YES to log actual rate to card. Set to
NO, otherwise.
3.
Exit back to main screen.
a)Press FIELD key twice.
b)Select appropriate field and press VIEW CONFIG key.
c)Select appropriate product/controller configuration and press
ACTIVE ON/OFF key to check it as active.(All other configs
must be unchecked first).
d)If you will be using a target file, press EDIT TGT FILE key,
otherwise press EXIT key and skip to step f.
e)Select target file. Press VIEW INFO key to ensure it is the
correct one. After exiting view info screen, press ACCEPT
key. Press EXIT key.
f)Press ACCEPT key to accept field.