HP StorageWorks 2.140 Director Switch - Manual (Page 85)

Monitoring and managing the Director
83 Director Element Manager User Guide
— 0x0D Fabric Binding Mismatch —Fabric Binding is enabled
and detected a connection with a switch or director with an incompatible
fabric membership list.
— 0x0E Authorization Failure Reject —The switch or director
on the other side of an ISL detected a security violation. Your switch
received notification via a generic reject code and sets its port to the
invalid attachment state in sympathy.
— 0x0F Unauthorized Switch Binding WWN —A Switch
Binding error was detected on either an E_Port or an F_Port.
— 0x10 Authentication Failure —ISL Authentication Check
(CHAP) failed.
— 0x11 Fabric Mode Mismatch —A connection was not allowed
because:
■ An HP M-Series switch or director attempted to connect to an HP
switch or director running in Open Fabric mode.
■ An HP M-Series switch or director running in Open Fabric mode
attempted to connect to another vendor’s switch or director with an
incorrect exchange link protocol (ELP) revision level.
— 0x12 CNT WAN Extension Mode Mismatch —The ELP
maximum frame sizes were incompatible because one product running in
CNT WAN extension mode attempted to connect to another product
running in a normal mode.
— 01 Unknown —The reason is not known.
— 02 ISL connection not allowed on this port —ISL is
connected to a port configured as an F_Port.
— 03 ELP rejected by the attached switch —This director
transmitted an exchange link protocol (ELP) frame that was rejected by
the switch at the other end of the ISL.
— 04 Incompatible switch at other end of the
ISL
—The switch is configured for Homogenous Fabric mode, and the
switch at the other end of the ISL is an HP switch configured for Open
Fabric 1.0 mode.
— 05 External loopback adapter connected to the
port
—A loopback plug is connected to the port, and no diagnostic test is
running.