HP StorageWorks 2.140 Director Switch - Manual (Page 251)

Information and Error Messages
249 Director Element Manager User Guide
Invalid response
received from director.
An error occurred at
the director during a
firmware download
operation.
Retry the firmware download
operation. If the problem
persists, contact the next level
of support.
Invalid serial number
for this feature key.
The serial number and
the feature key did not
match.
Ensure that the feature key
being installed is specifically
for this director serial number.
Invalid UDP port
number.
The specified user
datagram protocol
(UDP) port number is
invalid. The number
must be an integer
from 1 through 65535
inclusive.
Verify and enter a valid UDP
port number from 1 through
655535.
Invalid value for
BB_Credit.
At the Configure
Fabric Parameters
dialog box, the
buffer-to-buffer credit
(BB_Credit) value must
be an integer from 1
through 60 inclusive.
Verify and enter a valid
number between 1 through 60.
Invalid value for Low
BB Credit threshold
(1-99) %.
Low BB Credit
Threshold field in
Configure Open
Trunking dialog box
must have entries in
the range from 1 and
99. This message only
displays if the optional
Open Trunking feature
is installed.
Enter a value from 1 to 99 into
the Low BB Credit Threshold
field of the Configure Open
Trunking dialog box.
Invalid value for day
(1-31).
At the Configure Date
and Time dialog box,
the DD value (day)
must be an integer
from 1 through 31
inclusive.
Verify and enter a valid date.
Table 10: Element Manager Messages (Continued)
Message Description Action