beautypg.com

No feature key dialog box, Figure 47: no feature key dialog box, 47 no feature key dialog box – HP StorageWorks 2.140 Director Switch User Manual

Page 154

background image

Configuring the Director

152

Director Element Manager User Guide

No Feature Key Dialog Box

If you attempt to access a feature for which a feature key was not enabled, a No
Feature Key dialog box displays as shown in

Figure 47

.

Figure 47: No Feature Key dialog box

At this point, you must enter the Element Manager feature key. After you enter a
valid feature key, the Enable Feature Key dialog box displays.

Click Activate on the Enable Feature Key dialog box to activate the new feature
key. An IPL will occur, during which the Ethernet connection between the HAFM
appliance and director is momentarily interrupted. This will not disrupt Fibre
Channel traffic.

Note:

If you click Activate, all current features will be replaced with new features. That

is, if there are features shown in the current list that are not shown in the new list, then

those features will be removed from the switch or director.

Because the switch or director is placed offline when you activate the Element
Manager feature key, the Element Manager will not launch until it comes back
online and you either:

Right-click the switch or director and choose Element Manager.

Choose the switch or director and click the Launch Element Manager icon
from the tool bar.

This manual is related to the following products: