HP StorageWorks 2.140 Director Switch - Manual (Page 229)

Information and Error Messages
227 Director Element Manager User Guide
Routing is not
supported by the
switch.
This switch or director
does not support the
Show Routes feature.
Choose a different switch or
director to show the route.
SANtegrity Feature not
installed. Please
contact your sales
representative.
You selected Fabric
Binding or Enterprise
Fabric Mode from the
Fabrics menu. These
selections are not
enabled because the
optional SANtegrity
binding feature is not
installed.
Install the SANtegrity Binding
feature to use Fabric Binding or
enable Enterprise Fabric Mode.
Select alias to add to
zone.
An alias was not
selected before
clicking Add.
Choose an alias before clicking
Add.
Selection is not a
World Wide Name.
The selection made is
not a World Wide
Name.
Choose a valid World Wide
Name before performing this
operation.
Server shutting down. The HAFM application
is closing and
terminating
communication with
the attached product.
Reboot the HAFM appliance. If
the problem persists, contact
the next level of support.
SNMP trap address
not defined.
If an SNMP community
name is defined, a
corresponding SNMP
trap recipient address
must also be defined.
Enter a corresponding SNMP
trap recipient address.
Switch is not managed
by HAFM.
The selected switch or
director is not
managed by the
HAFM application.
Choose a different switch or
director.
The Administrator user
cannot be deleted.
The administrator user
is permanent and
cannot be deleted
from the Configure
Users dialog box.
Informational message
only—no action is required.
Table 9: HAFM Messages (Continued)
Message Description Action