HP Integrated Lights-Out 2 - Manual (Page 73)

•
IP Address
Use this parameter to assign a static IP address to iLO 2 on your network. By default, the IP
address is assigned by DHCP. By default, the IP address is 192.168.1.1 for all iLO 2
Diagnostic Ports.
•
Subnet Mask
— Use the subnet mask parameter to assign the subnet mask for the iLO 2 Diagnostic Port.
By default, the subnet mask is 255.255.255.0 for all iLO 2 Diagnostic Ports.
— The use of the Diagnostic Port is automatically sensed when an active network cable is
plugged in to it. When switching between the diagnostic and back ports, you must allow
90 seconds for the network switchover to complete before attempting connection through
the web browser.
NOTE: The diagnostic port does not switch over if an active Remote Console session
or a firmware update is in progress.
Static IP bay configuration 73