HP Integrated Lights-Out 2 - Manual (Page 72)

POST. If this is the case, exit any RBSU program you are running, allow POST to complete,
and try the operation again.
You can change the RAID level manually through RBSU. If the operating system is already installed,
changing the RAID level results in a loss of data.
Connect Virtual Media screen
This step of the installation wizard enables you to verify and accept the drive you will use during
the installation of the operating system. Under Settings, select the local drive and media type you
intend to use during operating system installation. Click Launch Virtual Media to launch the Virtual
Media applet.
•
Ensure the operating system media is connected. In the Virtual Media applet, a green icon
appears next to the media currently selected.
•
Verify that the operating system media is in the appropriate local drive.
•
Accept security certificates as they appear.
After making your selection, click Next to save your settings and continue. The virtual media applet
appears. After the applet is available, you can change the selected drive, or select other options
not available on the installation wizard page.
Install Software screen
This step of the installation wizard enables you to launch the Remote Console and install the
operating system. To start the operating system installation process:
•
Click Launch Software Installation to launch the Remote Console. iLO 2 automatically initiates
a server power-on or reboot to start the operating system installation through the previously
selected virtual media.
•
Accept security certificates as they appear.
Click Finish to complete the setup process.
iLO 2 diagnostic port configuration parameters
The iLO 2 Diagnostic Port on the front of ProLiant BL p-Class servers enables you to access and
troubleshoot server issues by using a diagnostic cable. The iLO 2 Diagnostic Port uses a static IP
address. It does not use DHCP to obtain an IP address, register with WINS or dynamic DNS, or
use a gateway. The diagnostic port cable must not be left plugged in without an active network
connection because it will cause degraded network performance on the standard iLO 2 network
port.
In Network Settings, you can configure specific diagnostic port information. For more information
on using the diagnostic port and the diagnostic cable, see to the setup and installation guide for
the blade server.
The following are the fields that can be configured for the Diagnostic Port:
•
Enable NIC
If Enable NIC is set to Yes, the diagnostic port is enabled.
•
Transceiver Speed Autoselect
•
Speed
•
Duplex
72 Configuring iLO 2